メインコンテンツにスキップ

Reemplazo del cristal trasero iPhone 14 Plus

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての6個のガイドに反映されます。

英語
スペイン語

手順 4を翻訳中

手順4
iPhone 14 Plus Rear Glass Replacement: 手順 0、 2の画像 1 iPhone 14 Plus Rear Glass Replacement: 手順 0、 2の画像 2
  • Support your iPhone on something sturdy such as a hardcover book so it rests hands-free and parallel to the ground; this makes it easier to work with in the following steps.

  • Use a hair dryer to heat along the bottom edge of the iPhone. The glass should feel slightly too hot to touch.

  • For complete instructions on how to use a hair dryer, check out this guide.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick under the rear glass when the Anti-Clamp creates a large enough gap.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle a quarter turn.

  • Don't crank more than a quarter turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next two steps.

Apoya tu iPhone sobre algo resistente, como un libro de tapa dura, para que descanse con las manos libres y paralelo al suelo; así te resultará más fácil trabajar con él en los pasos siguientes.

Usa un secador de cabello a lo largo del borde inferior del iPhone. El cristal debe sentirse ligeramente muy caliente para tocar.

Para instrucciones completas en como usar un secador de cabello, checa esta guía.

Espera un minuto para darle al adhesivo una oportunidad de soltarse y presentar un hueco de apertura.

Inserta una púa de apertura debajo del cristal trasero cuando el Anti-Clamp cree un hueco lo suficiente largo.

Si el Anti-Clamp no crea un hueco suficiente, aplica más calor al área y rota el mango un cuarto de giro.

No gires mas de un cuarto de giro a la vez, y espera un minuto entre giros. Deja que el Anti-Clamp y el tiempo haga su trabajo por ti.

Salta los siguientes dos pasos.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります