Power Macintosh G3 Blue and White Teardown

ガイドに戻る

英語

日本語

前の手順次の手順

手順 13を翻訳中

手順13

Power Macintosh G3 Blue and White Teardown: 手順 0、 3の画像 1

Power Macintosh G3 Blue and White Teardown: 手順 0、 3の画像 2

Power Macintosh G3 Blue and White Teardown: 手順 0、 3の画像 3

Removing the power supply
Disconnect the power connector from the logic board (this looks alot like a standard ATX connector. The lone difference is that the wire which supplies -5V on an ATX supply [pin 18] becomes a ground wire in the B&W G3. If you just plug in an ATX supply without any modifications, you'll short out its -5V output. )
There is a 4-Pin Cable connected to the front panel box, remove it.
Disconnect the internal fan cable.
The Fan Connector
Then Route all of the cables up through the case to the level of the power supply.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。