メインコンテンツにスキップ

Microsoft Surface Pro 6 Rückkamera tauschen

英語
ドイツ語

手順 1を翻訳中

手順1
Microsoft Surface Pro 6 Rear-Facing Camera Replacement, Remove the camera connector shield: 手順 0、 3の画像 1 Microsoft Surface Pro 6 Rear-Facing Camera Replacement, Remove the camera connector shield: 手順 0、 3の画像 2 Microsoft Surface Pro 6 Rear-Facing Camera Replacement, Remove the camera connector shield: 手順 0、 3の画像 3
Remove the camera connector shield
  • Insert one point of a pair of pointed tweezers into a gap in the corner of the EMI shield covering the camera connectors.

  • Use the tweezers to pry the EMI shield away from the motherboard as much as you can without bending it.

  • Repeat this procedure at different points around the shield until it is free. Remove the shield.

  • Try not to deform the shield too much—you will need to reinstall it during reassembly.

Setze eine der Spitzen einer abgewinkelten Pinzette in den Spalt an der Ecke der EMI-Abschirmung über den Kamerasteckern ein.

Heble die Abdeckung soweit wie möglich von der Hauptplatine weg, ohne sie zu verbiegen. Entferne sie noch nicht.

Wiederhole das an verschiedenen Stellen um die Abschirmung herum, bis sie sich abgelöst hat. Entferne die Abschirmung.

Verforme die Abschirmung nicht zu stark, du benötigst sie beim Zusammenbau wieder.

[title] Remove the camera connector shield
-[* black] Insert one point of a pair of pointed tweezers into a gap in the corner of the EMI shield covering the camera connectors.
+[* black] Insert one point of a pair of [product|IF145-020-2|pointed tweezers] into a gap in the corner of the EMI shield covering the camera connectors.
[* black] Use the tweezers to pry the EMI shield away from the motherboard as much as you can without bending it.
[* black] Repeat this procedure at different points around the shield until it is free. Remove the shield.
[* icon_caution] Try not to deform the shield too much—you will need to reinstall it during reassembly.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります