メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての17個のガイドに反映されます。

英語
日本語

手順 4を翻訳中

手順4
While cutting through the adhesive, don't insert the opening pick more than 5 mm into the phone or you risk damaging the internal components. Repeat the process of heating and cutting the adhesive along the three remaining sides of the rear cover. You can insert each new opening pick in the gaps created by the opening picks left in each corner.
Cut along the perimeter of the rear cover
  • While cutting through the adhesive, don't insert the opening pick more than 5 mm into the phone or you risk damaging the internal components.

  • Repeat the process of heating and cutting the adhesive along the three remaining sides of the rear cover.

  • You can insert each new opening pick in the gaps created by the opening picks left in each corner.

  • As you proceed, leave an opening pick in each corner to prevent the adhesive from re-sealing.

  • Slide an opening pick back and forth around the entire perimeter of the phone to release any missed adhesive. Reheat any stubborn adhesive.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります