メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての17個のガイドに反映されます。

英語
日本語

手順 2を翻訳中

手順2
Apply a suction cup to the heated edge of the rear cover, as close to the edge as possible. If your back glass is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere. Alternatively, very strong tape may be used instead of the suction cup. If all else fails, you can superglue the suction cup to the broken panel. Pull up on the suction cup with strong, steady force to create a gap between the rear cover and the frame.
Insert an opening pick
  • Apply a suction cup to the heated edge of the rear cover, as close to the edge as possible.

  • If your back glass is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere. Alternatively, very strong tape may be used instead of the suction cup. If all else fails, you can superglue the suction cup to the broken panel.

  • Pull up on the suction cup with strong, steady force to create a gap between the rear cover and the frame.

  • Depending on the age of your phone, this may be difficult. If you are having trouble, apply more heat to the edge and try again.

  • Insert an opening pick into the gap.

  • Don't insert the opening pick more than 5 mm into the phone or you risk damaging the internal components.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります