メインコンテンツにスキップ

Sostituzione cover posteriore Samsung Galaxy Note20 Ultra

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての17個のガイドに反映されます。

英語
イタリア語

手順 2を翻訳中

手順2
Samsung Galaxy Note20 Ultra Rear Cover Replacement, Insert an opening pick: 手順 0、 3の画像 1 Samsung Galaxy Note20 Ultra Rear Cover Replacement, Insert an opening pick: 手順 0、 3の画像 2 Samsung Galaxy Note20 Ultra Rear Cover Replacement, Insert an opening pick: 手順 0、 3の画像 3
Insert an opening pick
  • Apply a suction cup to the heated edge of the rear cover, as close to the edge as possible.

  • If your back glass is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere. Alternatively, very strong tape may be used instead of the suction cup. If all else fails, you can superglue the suction cup to the broken panel.

  • Pull up on the suction cup with strong, steady force to create a gap between the rear cover and the frame.

  • Depending on the age of your phone, this may be difficult. If you are having trouble, apply more heat to the edge and try again.

  • Insert an opening pick into the gap.

  • Don't insert the opening pick more than 5 mm into the phone or you risk damaging the internal components.

Fai aderire una ventosa al bordo scaldato del rivestimento posteriore, il più vicino possibile al bordo.

Se il vetro posteriore è rotto, coprirlo con uno strato di nastro adesivo trasparente potrebbe far aderire la ventosa. In alternativa, puoi usare del nastro resistente al posto della ventosa. Se hai ancora problemi, puoi incollare la ventosa al vetro rotto.

Tira verso l'alto la ventosa con forza costante per creare una fessura tra il rivestimento posteriore e la cornice.

A seconda dell'età del tuo telefono, questo può essere più o meno difficile. Se hai dei problemi, scalda ulteriormente il bordo e riprova.

Infila un plettro nella fessura.

Non infilare il plettro più di 5 mm nel telefono o rischi di danneggiare i componenti interni.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります