手順 6を翻訳中
手順6
Release Yoke and Spring Assembly
-
Remove the four 10mm J1 JIS head screws.
-
Pull the white assembly away from the cover and push the joystick handle toward the cover from the other side so that the sensors are accessible and free of the ribs in the cover that hold them in place.
-
Gently work each sensor out of it's mount, using care to support the fragile leads and wires. Note the orientation of the D-flat on each sensor "knob", the flat should be facing away from the solder tabs.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。