iPod Touch 7th Generation Front Panel Replacement

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての10個のガイドに反映されます。

ガイドに戻る

英語

イタリア語

前の手順次の手順

手順 4を翻訳中

手順4

iPod Touch 7th Generation Front Panel Replacement: 手順 0、 3の画像 1

iPod Touch 7th Generation Front Panel Replacement: 手順 0、 3の画像 2

iPod Touch 7th Generation Front Panel Replacement: 手順 0、 3の画像 3

Hold the iPod firmly against a table or bench.
Place your thumb and index finger over the lower corners of the display to stop the display from opening too far when the adhesive breaks.
Lift the suction cup up and back toward the top of the iPod. Be patient, and pull with firm, constant force until the adhesive breaks and the display comes up from the rear case.
It may be necessary to use a heat gun to soften the adhesive (especially in cooler climates). If you can pry the screen apart, and the adhesive is still sticking and pulling apart like cheese topping on a pizza, you can slide a thin razor blade in and gently cut the adhesive.
After the display begins to lift from the rear case, be careful not to lift more than about an inch—a fragile plastic frame still connects the display assembly to the rear case.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。