注意：あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。
手順 1を翻訳中
手順1
-
Remove the following sixteen screws from the metal midframe on the rear of the device:
-
Four 3 mm Phillips screw (located in each corner of the device - noted in red in the diagram)
-
Four 3 mm Phillips screws (surrounding the ports - noted in orange in the diagram)
-
Eight 3 mm Phillips screws (located around the body of the midframe - noted in yellow in the diagram)
| [* black] Remove the following sixteen screws from the metal midframe on the rear of the device: | |
| - | [* red] |
| - | [* orange] Four 3 mm Phillips screws surrounding the ports |
| - | [* yellow] Eight 3 mm Phillips screws |
| + | [* red] Four 3 mm Phillips screw (located in each corner of the device - noted in red in the diagram) |
| + | [* orange] Four 3 mm Phillips screws (surrounding the ports - noted in orange in the diagram) |
| + | [* yellow] Eight 3 mm Phillips screws (located around the body of the midframe - noted in yellow in the diagram) |
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。