メインコンテンツにスキップ

Teenage Engineering OP-Z バックカバーの交換

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての8個のガイドに反映されます。

英語
日本語

手順 1を翻訳中

手順1
Teenage Engineering OP-Z Back Cover Replacement: 手順 0、 3の画像 1 Teenage Engineering OP-Z Back Cover Replacement: 手順 0、 3の画像 2 Teenage Engineering OP-Z Back Cover Replacement: 手順 0、 3の画像 3
  • Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.

  • There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

親指または指先で4つのゴム足を反時計回りに90°回してロックを解除します。

どのゴム足にも、OP-Z下端側に向いた小さなマークがあります。回転させたら、オン/オフスイッチのある短辺側を向くはずです。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります