メインコンテンツにスキップ

Sostituzione gruppo scheda madre iPod Nano 4a Generazione

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての3個のガイドに反映されます。

英語
イタリア語

手順 4を翻訳中

手順4
iPod Nano 4th Generation Logic Board Assembly Replacement: 手順 0、 3の画像 1 iPod Nano 4th Generation Logic Board Assembly Replacement: 手順 0、 3の画像 2 iPod Nano 4th Generation Logic Board Assembly Replacement: 手順 0、 3の画像 3
  • Use the flat end of a spudger to separate the battery from the adhesive securing it to the outer case.

  • The lithium polymer battery used in the Nano is very flexible. Try not to deform it excessively while separating it from the outer case.

  • Use the flat end of a spudger to push the logic board assembly and battery slightly out of the bottom of the Nano. Stop once it pops out a little bit.

Usa la parte piatta di uno spudger per staccare la batteria dall'adesivo che la fissa al case esterno.

La batteria a ioni di litio usata nell'iPod Nano è molto fragile. Cerca di non deformarla troppo mentre la stacchi dall'adesivo.

Usa la parte piatta di uno spudger per spingere il gruppo della scheda madre e della batteria leggermente fuori dal bordo inferiore dell'iPod Nano. Fermati appena ne esce una parte.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります