ご注意:あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。
手順 9を翻訳中
手順9
Removing the Daughterboard
-
Remove the four T-6 screws holding the daughterboard to the controller frame. Keep in mind this board holds all of the remaining buttons in place, so be careful none of them are lost when removing this.
-
Note: All of the buttons have clips surrounding them that prevent any of the buttons from being installed in the wrong place; be sure not to force any of them into a different location when reassembling the device.
-
When reassembling, do not force anything into place as this could indicate something has been installed improperly.
-
That's it! Hopefully this guide allowed you to access any components that need replacing.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。