ご注意：あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。
手順 6を翻訳中
-
The wires will need to be desoldered from the board, and will be replaced later for reassembly.
-
Note: each pair of wires has the black cable soldered to the lower connection; keep this in mind for the reassembly if the pictures from this guide aren't nearby.
-
Note: You may be able to get away without desoldering these, depending on what you need to reach (credit to @bikemerlin), but due to the simplicity and fragility of these connections, I would suggest removing them to prevent additional damage.
-
Some of the solder in this controller requires a very high temperature to release. I had mine set to 450 C, however you may be able to remove it at a lower temperature.
-
Remove the two T-6 screws from the board near the vibration motors.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。