修理を始めるには コミュニティ ストア

手順7に変更

- Jeff Suovanenによって編集

承認済みの編集 : Jeff Suovanen

前
後
変更なし

手順ライン

[* black] With all the plastic bits out of the way, we can finally dig into the important parts of of the Studio.
[* black] We start with the high-powered half of the machine's hybrid hard disk: a standard, removable 64 GB SanDisk M.2 SSD:
[* red] SanDisk 05466 032G 32 GB NAND flash storage module (x2 for a total of 64 GB)
[* orange] Silicon Motion [http://www.siliconmotion.com/download.php?t=U0wyRnpjMlYwY3k4eU1ERTBMekE0THpBeEwzQnliMlIxWTNRNE1qYzRNakU1T1RNMkxuQmtaajA5UFZOTk1qSTBObGhVSUZCeWIyUjFZM1FnUW5KcFpXWmZUakEyTVRBPUM%3D|SM2246XT|new_window=true] SATA III 6 Gb/s DRAM-less SSD Controller
-[* icon_note] Amusingly, somewhere along the line, someone must have decided it would be more efficient to slap down two 32 GB chips, rather than four 16 GB chips, leaving a pair of empty solder pads.
- [* black] Or it was more efficient to leave extra spots for the high-end 128 GB models. Either way, if you have a couple flash storage modules and a hot air rework station lying around, the SSD controller will happily take up to four NAND flash devices.
+[* icon_note] Amusingly, someone must have decided it'd be better to slap down two 32 GB chips, rather than four 16 GB chips—hence this pair of empty solder pads.
+ [* black] Or was it simply more efficient to leave extra pads for the high-end 128 GB models? Either way, if you have a couple flash storage modules and a hot air rework station lying around, the SSD controller should happily take up to four NAND flash devices.