手順4に変更
- Jeff Suovanenによって編集
承認済みの編集 : Jeff Suovanen
- 前
- 後
- 変更なし
手順ライン
| [* black] Place the leads of the resistor through the holes on either side of the rectangle marked ***R1*** on the circuit board. | |
| [* icon_note] Resistors do not have to be installed in a particular orientation. Either lead can go into either hole. | |
| - | [* black] Turn the board over so that the copper traces are facing up and the resistor leads are pointing straight up in the air, as seen in the second picture |
| + | [* black] Turn the board over so that the copper traces are facing up and the resistor leads are pointing straight up in the air, as seen in the second picture. |
| [* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30° down from vertical is acceptable. |