手順3に変更
- Jeff Suovanenによって編集
承認済みの編集 : Jeff Suovanen
- 前
- 後
- 変更なし
手順ライン
| + | [* black] Pull off the black rubber stopper from your bottle of adhesive remover. |
|---|---|
| + | [* icon_caution] Twist to loosen or remove the bottle cap before you cut the applicator tip. |
| + | [* icon_note] This unseals the bottle and allows the pressure to equalize before you cut the applicator tip. ***If you skip this step, the adhesive remover may spray out unexpectedly when the tip is cut.*** |
| + | [* black] Use scissors to cut off the sealed tip of the applicator. |
| + | [* icon_note] Cutting close to the narrow tip will give you better control so you can apply the adhesive remover in small amounts. |
| + | [* icon_caution] Twist and close the bottle cap securely before you proceed further. |
画像1
以前の画像はありません
追加
画像2
以前の画像はありません
追加
画像3
以前の画像はありません
追加