Zoomer Jurassic World Indominus Rex Motherboard Replacement

はじめに

Motherboard is the most important component of a Zoomer Jurassic World Indominus Rex. If all else fails, we can always replace the motherboard. Knowing how to solder before attempting this guide is extremely encouraged. Details about soldering technique guide can be found at the last step of this guide.

必要な工具と部品

手順1 Back Cover

Zoomer Jurassic World Indominus Rex Motherboard Replacement, Back Cover: 手順 1、 1の画像 1

Turn off and unplug Zoomer Jurassic World Indominus Rex from any power source before doing replacements.
Remove all eight (8) 9.3mm Phillips screws using Phillips #1 screwdriver.

翻訳

手順2

Pry apart the back cover of the Jurassic Indominus Rex and the rest of the body using a spudger.
Do not take out the back cover immediately as it it still attached to the motherboard by a wire.

翻訳

手順3

Disconnect the orange wire that connects the motherboard and the back cover.
Separate the back cover and the rest of the Zoomer Jurassic World Indominus Rex.
Gently press the tab on the side of the orange connector if you are having trouble disconnecting the wire.

翻訳

手順4 Motherboard

Zoomer Jurassic World Indominus Rex Motherboard Replacement, Motherboard: 手順 4、 2の画像 1

Zoomer Jurassic World Indominus Rex Motherboard Replacement, Motherboard: 手順 4、 2の画像 2

Let the toy rest firmly on a flat surface before processing to the next step.
Gently pull each wire out of the connector on the motherboard. Use a set of tweezers, if necessary.

翻訳

手順5

Remove the two (2) #0 7.5mm phillips screws from the left side of the motherboard.
Remove the one (1) 7.5mm #0 phillips screw from the right side of the motherboard.

翻訳