WRS315SDHW Control Board Replacement

はじめに

Use this guide to replace the control board in your Whirlpool WRS315SDHW Refrigerator.

The control board processes the inputs for the dispenser assembly and other related assemblies. If your refrigerator is not dispensing properly, or if the dispenser buttons on your refrigerator aren't working, then your control board might be broken.

Note: Some photos show the doors removed for clarity purposes. Removing them is not required and will not change the procedure.

必要な工具と部品

手順1 Safety precautions

WRS315SDHW Control Board Replacement, Safety precautions: 手順 1、 1の画像 1

Before you begin your repair, perform the following:
Turn off your main water supply
Unplug your device

編集

手順2 Unfasten the dispenser panels

WRS315SDHW Control Board Replacement, Unfasten the dispenser panels: 手順 2、 2の画像 1

WRS315SDHW Control Board Replacement, Unfasten the dispenser panels: 手順 2、 2の画像 2

The dispenser panel screws are located under the dispenser as if you're looking up into the dispenser tube (where the ice cubes and water come out).
Use a 1/4 inch socket wrench to remove the two 15.6 mm-long screws securing the two dispenser panels.

編集

手順3 Remove the dispenser panels

WRS315SDHW Control Board Replacement, Remove the dispenser panels: 手順 3、 3の画像 1

WRS315SDHW Control Board Replacement, Remove the dispenser panels: 手順 3、 3の画像 2

WRS315SDHW Control Board Replacement, Remove the dispenser panels: 手順 3、 3の画像 3

Pull the dispenser panels straight down to separate them from the chassis.
Remove the dispenser panels.

編集

手順4 Unfasten the control board

WRS315SDHW Control Board Replacement, Unfasten the control board: 手順 4、 1の画像 1

Use a 1/4 inch socket wrench to remove the two 15.6 mm-long screws securing the control board.

編集

手順5

WRS315SDHW Control Board Replacement: 手順 5、 3の画像 3

Tilt the bottom of the control board away from the chassis to release its clips.
Pull straight down to separate the control board enough to access its connectors.

編集