必要な工具と部品
-
-
この手順は未翻訳です。 翻訳を手伝う。
-
I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward.
-
When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.
-
There are two problems, however:
-
Nothing pushes the throttle cable back out when I release the moped's throttle.
-
The throttle needle does not move, but to my understanding it should go upward when I apply the throttle.
-
Please check out my Answers question if you can help me solve this problem! Thanks a lot!
-