メインコンテンツにスキップ
英語
日本語

手順 6を翻訳中

手順6
I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward. When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.
  • I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward.

  • When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.

  • There are two problems, however:

  • Nothing pushes the throttle cable back out when I release the moped's throttle.

  • The throttle needle does not move, but to my understanding it should go upward when I apply the throttle.

  • Please check out my Answers question if you can help me solve this problem! Thanks a lot!

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります