Solio Rocsta Charging Cable Replacement

はじめに

The Solio Rocsta's charging cable is the main connection for charging/using your device. In this guide, we will show you how to replace your charging cable if it no longer works or needs repairing.

Please note that this guide requires soldering. For more information on how to solder and desolder connections, please visit this guide.

必要な工具と部品

手順1 Charging Cable

Solio Rocsta Charging Cable Replacement, Charging Cable: 手順 1、 2の画像 1

Solio Rocsta Charging Cable Replacement, Charging Cable: 手順 1、 2の画像 2

Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.

編集

手順2

Remove top cover.
Caution: the solar cell is attached to the top cover and connected to the circuit board by a short wire.

編集

手順3

Using the spudger, pry the battery off the back cover.

編集

手順4

Unscrew the 5.66 mm screws attaching the circuit board to the case.

編集

手順5

With the circuit board flipped, locate the battery connector.
Hold the component attached to the circuit board the battery is connected to and wiggle the cable out.

編集

手順6

With a Soldering Iron, desolder the four cables that connect the charging cable to the circuit board.
The power cable is a series of four cables. Make note of each cable placement for easy resoldering.
For more information on how to solder and desolder connections, please visit this guide.