メインコンテンツにスキップ

はじめに

This guide provides instructions on how to replace the flash component of the Samsung WB1100F.

  1. Remove six 1.2 mm Phillips #00 screws connected to the tripod dock and adjacent screws. Remove six 1.2 mm Phillips #00 screws from the side of the camera.
    • Remove six 1.2 mm Phillips #00 screws connected to the tripod dock and adjacent screws.

    • Remove six 1.2 mm Phillips #00 screws from the side of the camera.

  2. Use a plastic opening tool or spudger if available. Using the flat end of a spudger, loosen the connection between the back panel and the device. Remove the back  panel using your hands.
    • Use a plastic opening tool or spudger if available.

    • Using the flat end of a spudger, loosen the connection between the back panel and the device. Remove the back panel using your hands.

  3. Remove four 1.2 mm Phillips #00 screws from the top panel. Remove four 1.2 mm Phillips #00 screws from the top panel. Remove four 1.2 mm Phillips #00 screws from the top panel.
    • Remove four 1.2 mm Phillips #00 screws from the top panel.

  4. Using the flat end of a spudger, loosen the connection between the top panel and the device. Remove the top panel using your hands.
    • Using the flat end of a spudger, loosen the connection between the top panel and the device. Remove the top panel using your hands.

  5. Remove four 1.2 mm Phillips #00 screws from the flash assembly
    • Remove four 1.2 mm Phillips #00 screws from the flash assembly

  6. Using your hands, remove the flash assembly. This should not require much force.
    • Using your hands, remove the flash assembly. This should not require much force.

  7. Using your hands, remove the top flash panel by pressuring down on the back to release a locking tab. Using your hands, remove the top flash panel by pressuring down on the back to release a locking tab.
    • Using your hands, remove the top flash panel by pressuring down on the back to release a locking tab.

  8. Desolder three wires on the flash assembly.
    • Desolder three wires on the flash assembly.

  9. Gently remove the flash assembly from the body.
    • Gently remove the flash assembly from the body.

終わりに

To reassemble your device, follow these instructions in reverse order.

Jesse Lindsey

メンバー登録日: 2016年05月13日

530 ポイント

5のガイドは作成済み

チーム

Metro State, Team 1-1, Carpenter SU 2016 Metro State, Team 1-1, Carpenter SU 2016人のメンバー

MSU-CARPENTER-SU16S1G1

3 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 8

今までの合計 330