メインコンテンツにスキップ

必要なもの

  1. Samsung Captivate Speaker Replacement, Battery: 手順 1、 1の画像 1
    • Remove the back cover by pressing on the bottom section of the phone and sliding the bottom piece downward.

    • Lift up the back cover.

  2. Samsung Captivate Speaker Replacement: 手順 2、 1の画像 1
    • Place your finger on the bottom of the battery and lift to remove.

  3. Samsung Captivate Speaker Replacement: 手順 3、 1の画像 1
    • Replace the old battery with the new one.

  4. Samsung Captivate Speaker Replacement, Rear Case: 手順 4、 1の画像 1
    • Insert the spudger underneath the bottom section of the phone.

    • Gently lift and push the spudger to slide the bottom section down to reveal two hidden screws.

  5. Samsung Captivate Speaker Replacement: 手順 5、 1の画像 1
    • Remove the six 4.5mm #000 Phillips screws.

  6. Samsung Captivate Speaker Replacement: 手順 6、 3の画像 1 Samsung Captivate Speaker Replacement: 手順 6、 3の画像 2 Samsung Captivate Speaker Replacement: 手順 6、 3の画像 3
    • Starting at a bottom corner, use the spudger to separate the rear case from the front display.

    • Move the spudger towards the top on both sides. The plastic opening tool is easier to use for this step.

    • Be careful when detaching the top. Free each side, stopping short of the center of the cover. Apply backward pressure on both corners with a finger applying pressure on the center, and slide the whole back cover toward the bottom of the device. Note: forcing the cover can result in cracked plastic.

  7. Samsung Captivate Speaker Replacement: 手順 7、 1の画像 1
    • Separate the rear case from the phone.

  8. Samsung Captivate Speaker Replacement, Speaker: 手順 8、 1の画像 1
    • Use the Phillips 00 screwdriver to remove the single screw holding the speaker assembly to the LCD.

  9. Samsung Captivate Speaker Replacement: 手順 9、 2の画像 1 Samsung Captivate Speaker Replacement: 手順 9、 2の画像 2
    • Use the plastic opening tool to lift the bottom tab of the plastic ribbon cable connector. Be careful not to use excessive force, you are only releasing the tab that holds the cable in.

    • Pull out the ribbon cable.

    • Use a spudger or plastic opening tool to lift up the speaker, and use your hands to remove it.

終わりに

To reassemble your device, follow these instructions in reverse order.

11 の人々がこのガイドを完成させました。

Drew Bentz

メンバー登録日: 2011年09月22日

565 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 20-25, Maness Fall 2011 Cal Poly, Team 20-25, Maness Fall 2011人のメンバー

CPSU-MANESS-F11S20G25

3 メンバー

9のガイドは作成済み

コメント 1 件

It was clear enough to follow, don't know why it got the incorrect text caveat.

I gotta get one of those spudger sets.

Also it did not say where to get the actual replacement speaker.

G Trieste - 返信

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 6

今までの合計 8,688