はじめに
Use this guide to replace a broken phone connector cable on your Rotor Riot controller.
必要な工具と部品
-
-
Use your fingers to remove the screw on the back side of the controller securing the iPhone mount.
-
Remove the iPhone mount.
-
-
-
Use a T6 Torx screwdriver to remove the eight 9.2 mm-long screws securing the back cover.
-
-
-
Lift up the back cover of the controller.
-
Lift the back cover to a 45 degree angle and place it next to the controller.
-
-
-
-
Use a spudger to disconnect the phone connector cable from the mainboard.
-
-
-
Pull the screw thread bracket straight up to slide it off of the rails securing it to the back cover.
-
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Ask our Answers community for help.
