Replacing Atari Lynx Speaker

はじめに

This guide will show you how to replace the speaker from your Atari Lynx. Before beginning, it is a must to know how to solder and desolder. In order to find out how to do these processes there will be a link in the the following steps. Aside from soldering, most steps should be easy to follow and simple.

必要な工具と部品

手順1 Atari Lynx

Replacing Atari Lynx Speaker, Atari Lynx: 手順 1、 1の画像 1

Before disassembling your Atari Lynx, be sure the device is powered off.
Remove any game in the console by opening the right latch and sliding the game to the right.

翻訳

手順2

Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.
Pinch the rear panel with your fingers and lift away from the Atari.

翻訳

手順3

Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.
Be sure not to tear any wires attached to battery panel.

翻訳

手順4

Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.
Be sure not to tear the speaker wire while removing the control panel.

翻訳

手順5 Speaker

Replacing Atari Lynx Speaker, Speaker: 手順 5、 2の画像 1

Replacing Atari Lynx Speaker, Speaker: 手順 5、 2の画像 2

Remove the logic board from the console.
Flip the logic board so the screen is facing down.

翻訳

手順6

Now you will need to desolder both of the wires connected to the speaker.
If you are having trouble desoldering, click here.
Finally solder the new speaker back on and follow the previous steps in reverse order.