Protocol Videodrone AP Propeller Motors Replacement

はじめに

This guide shows how to replace the propeller motors for the Protocol Videodrone AP Drone. Working propeller motors are integral to making sure your drone flies properly. Before replacing the motors, make sure there is no debris that might be preventing the motors from rotating properly.

Remember to use the included screwdriver that came with your drone.

A soldering iron is required, so keep one ready.

必要な工具と部品

手順1 Propeller Motors

Protocol Videodrone AP Propeller Motors Replacement, Propeller Motors: 手順 1、 1の画像 1

Power off the drone before proceeding with the rest of the guide.

編集

手順2

Use the Phillips #0 screwdriver to remove four propeller screws.
If you don't own the screwdriver included with the drone kit, use a Phillips #0 screwdriver.

編集

手順3

Use the Phillips #0 screwdriver to remove eight propeller guard screws.

編集

手順4

Use the Phillips #0 screwdriver to remove eight housing screws from the bottom of the drone.

編集

手順5

Open up housing to reveal main circuit board.

編集

手順6

Use the Phillips #0 screwdriver to remove three motor housing screws. There are three screws per motor.
The plastic housing is glued directly to motor.

編集

手順7

Protocol Videodrone AP Propeller Motors Replacement: 手順 7、 3の画像 3

Desolder the wires connecting the propeller motor to the motherboard (2 per motor) and remove the motor from the device.
For more information on soldering connections, please visit the How to Solder and Desolder Connections guide.