ProntoTec Axius Motherboard Replacement

はじめに

All electrical components of the ProntoTec Axius tablet are connected to the motherboard. Water damage, dropping, and any other physical damage can cause the motherboard to short or malfunction; rendering the device unusable. This guide will highlight how to disconnect the motherboard from the other components of the device for replacement.

必要な工具と部品

手順1 Motherboard

ProntoTec Axius Motherboard Replacement, Motherboard: 手順 1、 1の画像 1

Make sure the device is completely turned off before you begging taking it apart to avoid electrocution risks.
Place the tablet face-up on a flat table.

編集

手順2

Starting near the headphone port, fit the flat end of the spudger in between the screen and back case.
Pry the back case from the screen around each point on the device to release the clips securing the case halves to each other.

編集

手順3

Gently remove the back case of the device and lay it in a flat surface as shown in the photo.
Make sure not to sever the wires (red and black) connected to the speaker that is located in the back case.

編集

手順4

Remove only the yellow tape that touches the motherboard
Be careful not to cut or damage the wires (red and black) that connect the battery to the motherboard.

編集

手順5

ProntoTec Axius Motherboard Replacement: 手順 5、 3の画像 3

Use a Phillips screwdriver (PH00) to unscrew the two screws that connects the motherboard to the device
Be careful not to cut or damage the wires (red and black) that connect the motherboard to the battery.

編集

手順6

Using a soldering iron, desolder the contact points of the speaker, battery and screen on the motherboard
If soldering is new to you, check out this helpful guide on soldering and desoldering connections.
Use pliers to pull the wire from the board

編集

手順7

Using the spudger, disconnect the ribbon cable connecting the camera to the motherboard

編集

手順8

ProntoTec Axius Motherboard Replacement: 手順 8、 3の画像 3

Using the spudger, push the black tabs towards the ribbon cable to unlock the ribbon cables that connect the screen to the motherboard.
Gently pull and remove the ribbon cables from the motherboard

編集