はじめに

Turn up the stereo sound on the DSi XL by replacing the volume control switch.

  1. Remove the two Phillips screws securing the battery cover to the back of the handheld console.
    • Remove the two Phillips screws securing the battery cover to the back of the handheld console.

    • Lift the battery cover off the back of the DSi XL.

    コメントを追加する

  2. Lift the battery from the DSi XL.
    • Lift the battery from the DSi XL.

    コメントを追加する

    • Remove the four rubber screw covers on the lower case by prying them up with a push pin.

    コメントを追加する

    • Remove the following seven Phillips screws that secure the lower case to the rest of the DSi XL:

      • Four silver 5.3 mm screws

      • Two black 5.3 mm screws

      • One black 2.5 mm screw

    コメントを追加する

    • Turn the DSi XL over, and open the display.

    • Insert a spudger between the upper and lower case at the bottom left corner of the DSi.

    • Slide the spudger along the bottom edge of the upper case to release the latches securing the upper case to the lower case.

    コメントを追加する

    • Close the display and turn the DSi XL over.

    • Lift the lower case from the front edge.

    • Rotate the lower case away from the DSi.

    • The lower case cannot be completely removed yet, since it is still connected to the motherboard.

    コメントを追加する

    • Using a spudger, pry the SD card/right shoulder button connector off its socket.

    • Pry the volume button/left shoulder button connector off its socket on the motherboard with a spudger.

    コメントを追加する

    • Remove the two gold 4.0 mm Phillips screws securing the left shoulder button assembly to the lower case.

    • Lift the left shoulder button assembly from the lower case.

    • The components of the left shoulder button assembly:

      • Left shoulder button

      • Shoulder button spring

      • Retaining pin

      • Left shoulder button support panel

    コメントを追加する

    • On the inside of the battery compartment, use the tip of a spudger to detach the metal latch securing the volume control switch in place.

    • The latch will only move about 1 mm.

    コメントを追加する

    • Using the flat end of a spudger, remove the adhesive securing the volume control switch ribbon cable to the back of the battery compartment.

    • Using the flat of a spudger, pry the volume control switch straight up out of the lower case.

    • Remove the volume control switch from the DSi XL.

    コメントを追加する

    • Using the flat end of a spudger, remove the volume control buttons from the metal backing bracket.

    • The bracket is attached by a strong adhesive. Work slowly and carefully, being sure to not damage the ribbon cable.

    • Volume control switch remains.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Brett Hartt

メンバー登録日: 2010年04月12日

108,299 ポイント

138のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

114 メンバー

7,025のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 7

今までの合計 5,028