はじめに

Regain power over your DSi XL by replacing or cleaning a faulty or sticky power button.

Remove the two Phillips screws securing the battery cover to the back of the handheld console.
  • Remove the two Phillips screws securing the battery cover to the back of the handheld console.

  • Lift the battery cover off the back of the DSi XL.

コメントを追加する

Lift the battery from the DSi XL.
  • Lift the battery from the DSi XL.

コメントを追加する

  • Remove the four rubber screw covers on the lower case by prying them up with a push pin.

コメントを追加する

  • Remove the following seven Phillips screws that secure the lower case to the rest of the DSi XL:

    • Four silver 5.3 mm screws

    • Two black 5.3 mm screws

    • One black 2.5 mm screw

コメントを追加する

  • Turn the DSi XL over, and open the display.

  • Insert a spudger between the upper and lower case at the bottom left corner of the DSi.

  • Slide the spudger along the bottom edge of the upper case to release the latches securing the upper case to the lower case.

コメントを追加する

  • Close the display and turn the DSi XL over.

  • Lift the lower case from the front edge.

  • Rotate the lower case away from the DSi.

  • The lower case cannot be completely removed yet, since it is still connected to the motherboard.

コメントを追加する

  • Using a spudger, pry the SD card/right shoulder button connector off its socket.

  • Pry the volume button/left shoulder button connector off its socket on the motherboard with a spudger.

コメントを追加する

  • Using the flat end of a spudger, flip up the retaining flap on the ZIF connector for the D-pad/power button cable.

  • With the pointed end of the spudger, pull the D-pad/power button cable from its connector on the motherboard.

コメントを追加する

  • Using the flat end of the spudger, carefully pry the battery cable out of its socket on the motherboard.

    • Use caution, as the wires are very fragile and could come out of the connector if pulled on too hard.

コメントを追加する

  • Remove the seven 2.5 mm silver screws securing the power board to the upper case.

  • Lift the power board off the upper case.

コメントを追加する

  • Lift the rubber pad off the back of the power button.

  • Open the display slightly and push the power button up through the upper case.

  • Remove the power button from the handheld console.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Brett Hartt

メンバー登録日: 2010年04月12日

107,440 ポイント

138のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

107 メンバー

6,518のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 3

過去 30 日: 11

今までの合計 6,884