はじめに

Get the power flowing through your DSi XL by replacing the power board.

  1. Remove the two Phillips screws securing the battery cover to the back of the handheld console.
    • Remove the two Phillips screws securing the battery cover to the back of the handheld console.

    • Lift the battery cover off the back of the DSi XL.

    コメントを追加する

  2. Lift the battery from the DSi XL.
    • Lift the battery from the DSi XL.

    コメントを追加する

    • Remove the four rubber screw covers on the lower case by prying them up with a push pin.

    コメントを追加する

    • Remove the following seven Phillips screws that secure the lower case to the rest of the DSi XL:

      • Four silver 5.3 mm screws

      • Two black 5.3 mm screws

      • One black 2.5 mm screw

    コメントを追加する

    • Turn the DSi XL over, and open the display.

    • Insert a spudger between the upper and lower case at the bottom left corner of the DSi.

    • Slide the spudger along the bottom edge of the upper case to release the latches securing the upper case to the lower case.

    コメントを追加する

    • Close the display and turn the DSi XL over.

    • Lift the lower case from the front edge.

    • Rotate the lower case away from the DSi.

    • The lower case cannot be completely removed yet, since it is still connected to the motherboard.

    コメントを追加する

    • Using a spudger, pry the SD card/right shoulder button connector off its socket.

    • Pry the volume button/left shoulder button connector off its socket on the motherboard with a spudger.

    コメントを追加する

    • Using the flat end of a spudger, flip up the retaining flap on the ZIF connector for the D-pad/power button cable.

    • With the pointed end of the spudger, pull the D-pad/power button cable from its connector on the motherboard.

    コメントを追加する

    • Using the flat end of the spudger, carefully pry the battery cable out of its socket on the motherboard.

      • Use caution, as the wires are very fragile and could come out of the connector if pulled on too hard.

    コメントを追加する

    • Remove the seven 2.5 mm silver screws securing the power board to the upper case.

    • Lift the power board off the upper case.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

Brett Hartt

メンバー登録日: 2010年04月12日

108,374 ポイント

138のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

114 メンバー

7,029のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 26

今までの合計 13,568