はじめに

This guide will take you through the process involved with installing an antenna. De-soldering and soldering will be required.

Rotate the device so that the bottom is facing up.
  • Rotate the device so that the bottom is facing up.

コメントを追加する

Lift up all four rubber pads on the bottom of the router with the plastic opening tool. Be careful not to pull the rubber pads all the way out when lifting as they are difficult to reinsert.
  • Lift up all four rubber pads on the bottom of the router with the plastic opening tool.

  • Be careful not to pull the rubber pads all the way out when lifting as they are difficult to reinsert.

コメントを追加する

Unscrew the four 11.8 mm T-8 torx screws from the bottom of the router. Unscrew the four 11.8 mm T-8 torx screws from the bottom of the router.
  • Unscrew the four 11.8 mm T-8 torx screws from the bottom of the router.

コメントを追加する

Lift the bottom casing straight up from the router.
  • Lift the bottom casing straight up from the router.

コメントを追加する

Remove the clear plastic casing by lifting it straight up from the router.
  • Remove the clear plastic casing by lifting it straight up from the router.

コメントを追加する

Separate the motherboard from the top shell by lifting it straight up from the router. Separate the motherboard from the top shell by lifting it straight up from the router.
  • Separate the motherboard from the top shell by lifting it straight up from the router.

コメントを追加する

Rotate the motherboard so that the top is facing up. Set the motherboard on a flat clean surface.
  • Rotate the motherboard so that the top is facing up.

  • Set the motherboard on a flat clean surface.

コメントを追加する

Do not refer to the pictures in this step for proper de-soldering and soldering techniques. They are for illustration purposes only. Refer to this link for proper de-soldering and soldering techniques.
  • Do not refer to the pictures in this step for proper de-soldering and soldering techniques. They are for illustration purposes only.

  • Refer to this link for proper de-soldering and soldering techniques.

  • Be patient. This may take some time depending on the quality of your soldering iron.

コメントを追加する

Peel off the yellow tape holding the wires.
  • Peel off the yellow tape holding the wires.

  • Set the tape aside on a clean surface so that it can be reused.

コメントを追加する

Extend the antenna outwards from the device so that it is straight. Locate the clips that hold the antenna onto the router.
  • Extend the antenna outwards from the device so that it is straight.

  • Locate the clips that hold the antenna onto the router.

  • Push the clips in with one hand and pull the antenna out with your other hand. Slightly twist the antenna until it becomes free from the hole.

コメントを追加する

Pull out the antenna as well as the connected wire.
  • Pull out the antenna as well as the connected wire.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

Ryan Murphy

メンバー登録日: 2011年10月03日

482 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 21-24, Maness Fall 2011 Cal Poly, Team 21-24, Maness Fall 2011人のメンバー

CPSU-MANESS-F11S21G24

4 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 6

過去 30 日: 40

今までの合計 6,019