はじめに

Before proceeding with the replacement guide, please ensure the headphones are unplugged from any device.

See the speaker replacement guide and follow steps 1 and 2.
  • See the speaker replacement guide and follow steps 1 and 2.

コメントを追加する

Use the T6 torx screwdriver to remove the seven screws located around the headphone cover and place the screws in a safe place.
  • Use the T6 torx screwdriver to remove the seven screws located around the headphone cover and place the screws in a safe place.

  • To avoid stripping screws, be sure to use the right drill bit oriented perpendicular to the face of the screw.

コメントを追加する

  • Carefully lift the speaker out of its housing while leaving all wires connected.

コメントを追加する

  • Lift the module out of the headphone cup, leaving all wires attached.

  • Clip the two wires circled in orange.

  • Now that the speaker is free set it aside.

  • Clip the two wires circled in yellow.

  • Replace speaker module and solder it to the two wires circled in orange.

  • Now solder the speaker wires (circled in yellow) back to the module.

  • For soldering see the ifixit soldering guide: How To Solder and Desolder Connections

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Ben

メンバー登録日: 2014年02月24日

104 ポイント

1ガイドが承認済み

チーム

Michigan Tech, Team 5-1, Lauer Spring 2014 Michigan Tech, Team 5-1, Lauer Spring 2014人のメンバー

MTU-LAUER-S14S5G1

2 メンバー

3のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 133