メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

はじめに

This guide will be helpful for users who are in need of replacing the speakers on their headphones. You will need to know how to solder in order to complete this guide.

  1. Make sure the headphones are off and unplugged from any devices.
    • Make sure the headphones are off and unplugged from any devices.

    • Remove leather headphone cushion by pulling edge towards middle of headphone.

    • It should slip off the device.

  2. Carefully peel back foam pad to prevent tearing.
    • Carefully peel back foam pad to prevent tearing.

    • It is glued at both the top and bottom.

  3. Use the T6 torx screwdriver to remove the three screws holding the speaker in place.
    • Use the T6 torx screwdriver to remove the three screws holding the speaker in place.

    • To avoid stripping screws, be sure to use the right screw bit oriented perpendicular to the face of the screw.

  4. With the speaker removed from the speaker module, clip the black and white wires on the back of the speaker, as shown.
    • With the speaker removed from the speaker module, clip the black and white wires on the back of the speaker, as shown.

    • Solder wires onto corresponding pads of replacement speaker.

    • For soldering see the ifixit soldering guide: はんだ付けとはんだ除去の作業ガイド

終わりに

To reassemble your device, follow these instructions in reverse order.

John Ware

メンバー登録日: 2014年02月24日

325 ポイント

2のガイドは作成済み

チーム

Michigan Tech, Team 5-1, Lauer Spring 2014 Michigan Tech, Team 5-1, Lauer Spring 2014人のメンバー

MTU-LAUER-S14S5G1

2 メンバー

3のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 3

今までの合計 273