メインコンテンツにスキップ

この修理ガイドは変更されています。最新の未承認バージョンに切り替えます。

Arthur Rosenthal Academic Book Publisher Dies at

必要な工具と部品

  1. Arthur Rosenthal Academic Book Publisher Dies at, Battery: 手順 1、 1の画像 1
    • Use your fingers to push both battery release tabs away from the battery, and lift the battery out of the computer.

  2. Arthur Rosenthal Academic Book Publisher Dies at, RAM Shield: 手順 2、 1の画像 1
    • Remove the three identical Phillips screws from the memory door.

  3. Arthur Rosenthal Academic Book Publisher Dies at: 手順 3、 1の画像 1
    • Lift the memory door up enough to get a grip on it, and slide it toward you, pulling it away from the casing.

  4. Arthur Rosenthal Academic Book Publisher Dies at, Upper Case: 手順 4、 1の画像 1
    • Remove the two 2.8 mm Phillips screws in the battery compartment near the latch.

  5. Arthur Rosenthal Academic Book Publisher Dies at: 手順 5、 1の画像 1
    • Remove the following 6 screws:

    • Two 10 mm T6 Torx screws on either side of the RAM slot.

    • Four 14.5 mm Phillips screws along the hinge.

  6. Arthur Rosenthal Academic Book Publisher Dies at: 手順 6、 1の画像 1
    • Remove the four 3.2 mm Phillips screws on the port side of the computer.

  7. Arthur Rosenthal Academic Book Publisher Dies at: 手順 7、 1の画像 1
    • Rotate the computer 90 degrees and remove the two 3.2 mm Phillips screws from the rear of the computer.

  8. Arthur Rosenthal Academic Book Publisher Dies at: 手順 8、 1の画像 1
    • Rotate the computer 90 degrees again and remove the four 3.2 mm Phillips screws from the side of the computer.

  9. Arthur Rosenthal Academic Book Publisher Dies at: 手順 9、 1の画像 1
    • Do not yank the upper case off quickly. The case is attached to the logic board via a ribbon cable.

    • Lift up at the rear of the case and work your fingers along the sides, freeing the case as you go. Once you have freed the sides, you may need to rock the case up and down to free the front of the upper case (there are some hidden plastic clips that need to be clicked off).

  10. Arthur Rosenthal Academic Book Publisher Dies at: 手順 10、 1の画像 1
    • Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary.

    • Remove the upper case.

  11. Arthur Rosenthal Academic Book Publisher Dies at, Optical Drive: 手順 11、 1の画像 1
    • Disconnect the orange SuperDrive ribbon cable from the logic board, removing tape as necessary.

  12. Arthur Rosenthal Academic Book Publisher Dies at: 手順 12、 1の画像 1
    • Remove the following 4 screws:

    • Two 3.3 mm silver Phillips screws on either side of the SuperDrive.

    • One 4.7 mm silver T6 Torx screw from the top left corner of the drive

    • One 6.2 mm black Phillips screw at the top right corner of the drive.

  13. Arthur Rosenthal Academic Book Publisher Dies at: 手順 13、 1の画像 1
    • Lift the optical drive up and out of the computer.

  14. Arthur Rosenthal Academic Book Publisher Dies at, PRAM Battery: 手順 14、 1の画像 1
    • Disconnect the PRAM battery cable from the bottom right corner of the logic board.

  15. Arthur Rosenthal Academic Book Publisher Dies at: 手順 15、 1の画像 1
    • Use a spudger to pry up the PRAM battery from the lower case.

    • Lift the PRAM battery out of the computer.

終わりに

To reassemble your device, follow these instructions in reverse order.

8 の人々がこのガイドを完成させました。

iRobot

メンバー登録日: 09/24/09

1 ポイント

636のガイドは作成済み

コメント 1 件

Great Guide! Thanks! Got the weakened BIOS/PRAM changed, without having to touch the m/b at all, very fine!

Pertti Vanhatalo - 返信

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 12

今までの合計 25,559