メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

はじめに

Use this guide to remove the rear lens cover of your LG V20.

  1. Press the button on the lower right side of the LG V20 to open the clamp that holds the back cover on the back side of the phone. Remove the back cover. Remove the back cover.
    • Press the button on the lower right side of the LG V20 to open the clamp that holds the back cover on the back side of the phone.

    • Remove the back cover.

  2. Before disassembling your phone, discharge the battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured. Use the flat end of a spudger and insert it in the small recess at the lower end of the battery. Use the spudger to lever out the battery and remove it.
    • Before disassembling your phone, discharge the battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

    • Use the flat end of a spudger and insert it in the small recess at the lower end of the battery.

    • Use the spudger to lever out the battery and remove it.

    • You can do this with your fingers but take care not to puncture the battery with your fingernails.

  3. 今あるものを使い続けましょう

    オールインワインキットで安く修理して、節約しましょう。

    iPhone 修理キットを見る

    今あるものを使い続けましょう

    オールインワインキットで安く修理して、節約しましょう。

    iPhone 修理キットを見る
  4. Use an iOpener to loosen the adhesive beneath the rear lens cover.
  5. Use the tip of an opening pick to gently pry up the rear lens cover. Use the tip of the opening pick and slide around the whole rear lens cover to cut the adhesive beneath. Use the tip of the opening pick and slide around the whole rear lens cover to cut the adhesive beneath.
    • Use the tip of an opening pick to gently pry up the rear lens cover.

    • Use the tip of the opening pick and slide around the whole rear lens cover to cut the adhesive beneath.

  6. Remove the rear lens cover.
    • Remove the rear lens cover.

終わりに

To reassemble your device, follow these instructions in reverse order. Apply new adhesive where it’s necessary.

5 の人々がこのガイドを完成させました。

Dominik Schnabelrauch

メンバー登録日: 2016年11月23日

71,156 ポイント

320のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

128 メンバー

13,023のガイドは作成済み

3 件のコメント

Need to be careful not to pull the flash bits as well.

David Nevill - 返信

My rear camera lens cover stack fell off. The flash array, the two cameras and the sensors on the right are in place. The rubber 'rings' around the flash and sensors are gone and everything above them is gone.

How do I get all of the pieces?

Is it called a “lens cover stack" or something like that?

Bill Lipe - 返信

It's hard to tell from the pictures but the lens cover is actually 2 pieces. There is a metal piece that the actual glass fits into but you can only see the outside edge of it. So if you accidentally break the glass camera cover like I did and order a replacement piece, they are probably only going to send you the glass. You'll have to use something sharp to scrape the broken glass and adhesive off of the metal piece and then use new adhesive to stick the glass to the metal piece. Then you can insert the little LED cover and stick this assembly to the the back of the phone.

Transam6.6 - 返信

コメントを追加

統計データを表示:

過去 24時間: 3

過去 7 日: 11

過去 30 日: 56

今までの合計 1,702