Jabra Speak 510 Speaker Replacement

作成者： Jordan Murphy (と他の投稿者)

コメント: 4
お気に入り: 0
完了: 4

難易度

普通

手順

所要時間

10 - 20 分

はじめに

If the speaker is distorted or not functioning, you may need to replace it. This guide will give you step-by-step instructions on how to replace the speaker in the Jabra Speak 510.

ツール

パーツ

パーツは指定されていません。

手順1 Outer Casing

Using a metal spudger, peel back the foam pad on the bottom of the device to reveal six screws.

Using a metal spudger, peel back the foam pad on the bottom of the device to reveal six screws.

翻訳

手順2

Remove the six 20 mm T6 screws from the bottom of the device.

Remove the six 20 mm T6 screws from the bottom of the device.

翻訳

手順3

Remove the back plate and the grey foam underneath.

Remove the back plate and the grey foam underneath.

翻訳

手順4

Use a small, pointed metal spudger to release the plastic tabs connecting the faceplate to the bottom of the speaker.

A small cable connects the faceplate to the device. Carefully disconnect the cable before fully opening the device.

Slowly flip the device open like a clam shell.

Use a small, pointed metal spudger to release the plastic tabs connecting the faceplate to the bottom of the speaker.
A small cable connects the faceplate to the device. Carefully disconnect the cable before fully opening the device.
Slowly flip the device open like a clam shell.
There are several wires soldered to the motherboard that prevent the faceplate from detaching completely.