Huawei Honor 8 Rear Glass Removal

はじめに

Use this guide to remove the rear glass of the Huawei Honor 8.

You’ll need replacement adhesive to reattach components when reassembling the device.

必要な工具と部品

手順1 Rear Glass

Huawei Honor 8 Rear Glass Removal, Rear Glass: 手順 1、 1の画像 1

Before you begin, switch off your phone.
Apply a heated iOpener to the back of the phone to loosen the adhesive beneath the rear glass. Apply the iOpener for at least two minutes.

編集

手順2

Huawei Honor 8 Rear Glass Removal: 手順 2、 3の画像 3

If the phone's rear glass is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.
Secure a suction handle to the lower edge of the rear glass, as close to the edge as possible.
Lift the rear glass with the suction cup to create a small gap between the glass and the frame.
Insert an opening pick into the gap.
If you have trouble, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.
Slide the opening pick to the bottom right corner.

編集

手順3

Insert a second opening pick and slide it to the bottom left corner to cut the adhesive.
Leave the opening picks in place to prevent the adhesive from resealing.

編集

手順4

Huawei Honor 8 Rear Glass Removal: 手順 4、 3の画像 3

The fingerprint cable is located above the power and volume buttons on this side of the phone. Only use the tip of the opening pick in this area to avoid damage.
Insert a third opening pick at the bottom left corner.
Start to slide the tip of the opening pick from the bottom left corner along the side to cut the adhesive.
Leave the opening pick in its place at the top left corner to prevent the adhesive from resealing.

編集

手順5

If the adhesive gets hard to cut it most likely cooled down. Use your iOpener to reheat it.
Insert a fourth opening pick under the top left corner of the rear glass.
Slide the opening pick along the top edge of the phone to cut the adhesive.
Leave the opening pick in the top right corner to prevent the adhesive from resealing.

編集

手順6

Insert a fifth opening pick at the top right corner of the phone.
Slide the opening pick along the right side to cut the remaining adhesive.
The fingerprint cable is still connected to the motherboard. Don't try to remove the rear glass all the way yet.

編集

手順7

Carefully lift the rear glass and fold it to the left side of the Honor 8.

編集

手順8

Remove the Phillips #00 screw (2.8 mm length) that secures the metal bracket on top of the fingerprint flex connector.

編集

手順9

Use a pair of tweezers to remove the metal bracket that sits on top of the fingerprint and display flex connectors.

編集

手順10

Use a spudger to pry up and disconnect the fingerprint flex connector.

編集

終わりに

Secure the new back cover with pre-cut adhesive or double-sided adhesive tape.

To reassemble your device, follow these instructions in reverse order.

After installing the rear cover, apply strong, steady pressure to your phone for several minutes to help the adhesive form a good bond, such as by placing it under a stack of heavy books.

Repair didn’t go as planned? Check out our Answers community for troubleshooting help.

2 の人々がこのガイドを完成させました。