メインコンテンツにスキップ

はじめに

In order for your Hover-1 Coast to be used, you must have a functioning controller. It is essential to have a fully functioning controller for the Hover-1 Coast to be used to it's full potential. This guide is not too difficult and can be done by anyone.

  1. Identify the three screws and using a Phillips #1 screwdriver loosen the the screws. Remove the three screws. Remove the three screws.
    • Identify the three screws and using a Phillips #1 screwdriver loosen the the screws.

    • Remove the three screws.

  2. Pull the backside of the controller off. The inside of the controller should look like this. The marked area is the battery.
    • Pull the backside of the controller off.

    • The inside of the controller should look like this.

    • The marked area is the battery.

  3. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  4. Remove the black foam piece covering the battery.
    • Remove the black foam piece covering the battery.

  5. Desolder the battery connections from the motherboard. Desolder the battery connections from the motherboard.
    • Desolder the battery connections from the motherboard.

  6. Using a plastic opening tool, pry the battery off the motherboard. The inside of the controller should look like this.
    • Using a plastic opening tool, pry the battery off the motherboard.

    • The inside of the controller should look like this.

まとめ

To reassemble your device, follow these instructions in reverse order.

Jace Oppenlander

メンバー登録日: 2018年10月04日

521 ポイント

4のガイドは作成済み

チーム

Linn Benton Community College, Team S2-G2, Karnes Fall 2018 Linn Benton Community College, Team S2-G2, Karnes Fall 2018人のメンバー

LBCC-KARNES-F18S2G2

3 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 3

過去 30 日: 9

今までの合計 88