はじめに

Replacing the logic board of an HTC EXCA100

  1. Remove the rubber screw covers. If needed, use a thin object to help pry them off. There should be two of them on top of the phone. Skip this step if already removed.
    • Remove the rubber screw covers. If needed, use a thin object to help pry them off. There should be two of them on top of the phone. Skip this step if already removed.

    • Pry loose the metal cover near the camera lens, circled in the picture.

    コメントを追加する

  2. Remove the battery cover.
    • Remove the battery cover.

    • Gripping the battery by the bottom, lift and remove it from the phone.

    コメントを追加する

  3. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • After removing the rubber stoppers on top, there should be six exposed screws. Remove these using the T6 screwdriver.

    • Next, use the spudger to loosen the case underneath the shiny metal edge. Go all the way around the phone until completely loosened.

      • The case is superglued on and will not permanently damage the phone when removed, but you should still use caution.

    • After loosening the case, remove it.

      • There is a wire that connects both the top and bottom of the case. If you are not careful when removing the case, you might snap the wire.

    コメントを追加する

    • Remove the one remaining screw in the logic board.

    • Unclip the wire that connects the back of the case to the logic board.

    コメントを追加する

    • On the left side of the phone, there are three copper colored clips.

      • Unclip the bottom clip, thread the middle one through the logic board, and pull the top one out gently.

    • You can then lift the logic board out of the phone.

      • Do this at an angle, lifting the side to the right of the SIM card instructions.

      • One of the strips is attached to the front of the case, and goes through the logic board. Be careful not to break this piece.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Ian Mitchell

メンバー登録日: 2011年04月19日

142 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 25-27, Garner Spring 2011 Cal Poly, Team 25-27, Garner Spring 2011人のメンバー

CPSU-GARNER-S11S25G27

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 2,099