手順番号3–HTC Excalibur Logic Board Replacementを翻訳 - iFixit

修理を始めるには

修理する権利

パーツ＆ツール

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての3個のガイドに反映されます。

ガイドに戻る

英語

日本語

前の手順次の手順

手順 3を翻訳中

手順3

After removing the rubber stoppers on top, there should be six exposed screws. Remove these using the T6 screwdriver.

Next, use the spudger to loosen the case underneath the shiny metal edge. Go all the way around the phone until completely loosened.

The case is superglued on and will not permanently damage the phone when removed, but you should still use caution.

After removing the rubber stoppers on top, there should be six exposed screws. Remove these using the T6 screwdriver.
Next, use the spudger to loosen the case underneath the shiny metal edge. Go all the way around the phone until completely loosened.
The case is superglued on and will not permanently damage the phone when removed, but you should still use caution.
After loosening the case, remove it.
There is a wire that connects both the top and bottom of the case. If you are not careful when removing the case, you might snap the wire.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。