Google Pixel XL Opening Procedure

はじめに

Prereq only! Opening procedure for the Google Pixel XL. Removes midframe.

The Pixel XL’s unreinforced display panel is fragile and is attached to the frame with strong adhesive, making repairs difficult. There is a considerable chance of breaking the display, especially if it already has micro-fractures. Be sure to apply plenty of heat and be extremely careful during the prying stage.

必要な工具と部品

手順1 Google Pixel XL Opening Procedure

Google Pixel XL Opening Procedure, Google Pixel XL Opening Procedure: 手順 1、 1の画像 1

Remove the following screws that secure the midframe to the back:
Seven black 4 mm T5 screws
Two silver 3 mm T5 screws

翻訳

手順2

The midframe is held tightly in place by plastic clips which push into the edge of the back case.

翻訳

手順3

Google Pixel XL Opening Procedure: 手順 3、 3の画像 3

Find the small notch in the bottom left corner of the frame and insert an opening pick.
Slide the opening pick along the bottom edge of the phone towards the bottom right corner and leave it there.

翻訳

手順4

Google Pixel XL Opening Procedure: 手順 4、 3の画像 3

Insert a separate opening pick into the right edge of the phone, near the bottom.
Slowly push the pick upwards along the seam until the first clip pops free.
Due to the tight tolerances, this may be difficult, requiring a substantial amount of force. If you are having trouble, try inserting and sliding a playing card.
Once you've released the clip, leave the opening pick in place to prevent the midframe from resealing.

翻訳

手順5

Insert an opening pick into the right edge of the phone and slide it upwards towards the top right clip.
You do not need to insert the pick more than 2 mm into the edge. If you insert the pick all the way in, you may risk damaging flex cables.
Slowly slide the pick past the clip to disengage it from the frame.
At this point, the right edge of the midframe should be free from the case. If it isn't, slide an opening clip up and down along the right edge.

翻訳

手順6

Google Pixel XL Opening Procedure: 手順 6、 3の画像 3

Grasp the right edge of the midframe by the corners and slowly hinge the edge up.
When the left edge feels loose, stop hinging and lift the midframe upwards.
Remove the midframe.
To reinstall the midframe, align it to the case, then squeeze around the perimeter until all the clips snap back into position. When properly done, the midframe should lie flat.