はじめに

Removing the logic board from the Garmin Nuvi 200

Peel off the sticker from the bottom of the device to reveal two screws. Peel off the sticker from the bottom of the device to reveal two screws.
  • Peel off the sticker from the bottom of the device to reveal two screws.

コメントを追加する

Remove two T5 Torx screws.
  • Remove two T5 Torx screws.

コメントを追加する

Insert a plastic opening tool in the gap between the front and rear casing. Carefully work the tool around the gap, separating the two halves of the case.
  • Insert a plastic opening tool in the gap between the front and rear casing.

  • Carefully work the tool around the gap, separating the two halves of the case.

    • Keep the power switch in place while removing the rear case.

コメントを追加する

Peel away the tape holding the ribbon cable in place.
  • Peel away the tape holding the ribbon cable in place.

  • Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.

コメントを追加する

Pull out the cable between the logic board and the speaker to disconnect them.
  • Pull out the cable between the logic board and the speaker to disconnect them.

コメントを追加する

Remove the three screws from the logic board using the #00 Phillips screwdriver. Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.
  • Remove the three screws from the logic board using the #00 Phillips screwdriver.

  • Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.

コメントを追加する

Detach the logic board form the battery by pulling out the cable. Detach the logic board form the battery by pulling out the cable.
  • Detach the logic board form the battery by pulling out the cable.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Anjelica

メンバー登録日: 2010年04月11日

504 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 25-90, Amido Spring 2010 Cal Poly, Team 25-90, Amido Spring 2010人のメンバー

CPSU-AMIDO-S10S25G90

4 メンバー

9のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 12

過去 30 日: 33

今までの合計 9,543