DR.J Professional HI-04 Lens Replacement

はじめに

Use this guide to replace the lens in a DR.J Professional HI-04 if the device is displaying a blurry or distorted image.

The lens is what allows the device to project an image. A faulty lens can cause the image to look distorted or blurry. This can be caused by the lens being scratched or broken.

Before using this guide, be sure to review the troubleshooting page. Sometimes the image may be blurry or distorted due to the keystone needing to be adjusted, which would not require replacing the lens.

必要な工具と部品

手順1 Lens

DR.J Professional HI-04 Lens Replacement, Lens: 手順 1、 3の画像 1

DR.J Professional HI-04 Lens Replacement, Lens: 手順 1、 3の画像 2

DR.J Professional HI-04 Lens Replacement, Lens: 手順 1、 3の画像 3

Flip the projector so that the bottom is facing up.
Remove eight 10.0 mm screws from the back case with a Phillips #0 screwdriver.
The screws are set deep in the holes, so be careful not to drop them.
Remove two 20.0 mm screws with a Phillips #0 screwdriver.

編集

手順2

DR.J Professional HI-04 Lens Replacement: 手順 2、 3の画像 3

Flip the projector so it is upright.
Remove the top case of the projector.
The shell of the projector should lift up easily but is fragile, so be gentle while lifting.
The top case is connected to the motherboard by cables, so avoid yanking it off to prevent snapping the connectors or damaging components.