はじめに

Before starting this guide you may need some experience with soldering/ desoldering. If you do not know how, you can learn by clicking the link we put on step 8 (when you have to desolder the backlight).

Before disassembling your Atari Lynx, be sure the device is powered off.
  • Before disassembling your Atari Lynx, be sure the device is powered off.

  • Remove any game in the console by opening the right latch and sliding the game to the right.

コメントを追加する

Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.
  • Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.

  • Pinch the rear panel with your fingers and lift away from the Atari.

コメントを追加する

Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.
  • Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.

  • Be sure not to tear any wires attached to battery panel.

コメントを追加する

Remove the control panel by pinching the sides with your fingers and lifting  it away from the Atari.
  • Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.

  • Be sure not to tear the speaker wire while removing the control panel.

コメントを追加する

Pull out the logic-board.
  • Pull out the logic-board.

  • Pull to the sides the four rubber tabs holding in the screen

コメントを追加する

Unscrew the two 10 mm screws as shown with a Phillips #0 screwdriver in order to remove the shield behind the backlight.
  • Unscrew the two 10 mm screws as shown with a Phillips #0 screwdriver in order to remove the shield behind the backlight.

コメントを追加する

Flip over the motherboard and remove the shield behind the backlight.
  • Flip over the motherboard and remove the shield behind the backlight.

コメントを追加する

Flip the motherboard back over and desolder the two components that are holding the backlight in place. If you need help with basic desoldering, click here.
  • Flip the motherboard back over and desolder the two components that are holding the backlight in place.

  • If you need help with basic desoldering, click here.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

John Lopez

メンバー登録日: 2014年01月27日

440 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 1-42, Maness Winter 2014 Cal Poly, Team 1-42, Maness Winter 2014人のメンバー

CPSU-MANESS-W14S1G42

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 5

過去 30 日: 31

今までの合計 2,035