Apple XServe Raid Battery Replacement

はじめに

If your Xserve 2,1 is showing an error in Raid Utility about the backup battery, this guide will show you how to replace the raid battery in the system.

The raid battery serves as a way to write cached data to the system drives if there is a power failure. This ability is important in systems with raid, as it protects the user from data loss.

If the raid battery has recently been replaced, ensure that the system has been powered on for a minimum of 72 hours and battery conditioning has finished.

Before using this guide, ensure that you have a grounded working surface and anti-static wristband. Static electricity may cause damage to the internal components of the system.

Always dispose of the battery according to local laws and regulations, and if the battery has become swollen, make sure not to damage the enclosure.

必要な工具と部品

手順1 Raid Battery

Apple XServe Raid Battery Replacement, Raid Battery: 手順 1、 2の画像 1

Apple XServe Raid Battery Replacement, Raid Battery: 手順 1、 2の画像 2

Remove the drive module(s) from the front of the Xserve.
Depending on configuration, there may be up to three modules.

編集

手順2

Remove the power supplies from the system by pulling on the built-in removal bar.
Depending on configuration, there may only be one power supply unit.

編集

手順3

Remove the top cover of the system by loosening the two thumb screws located on the back panel.
Discharge any static electricity by touching a grounded surface. Failure to do so may cause damage to the internal components.

編集

手順4

Apple XServe Raid Battery Replacement: 手順 4、 3の画像 3

Remove the fan module by loosening the two Phillips #0 screws located on each side of the module.

編集

手順5

Disconnect the raid battery connector using a plastic spudger.

編集

手順6

Remove the SAS backplane power cable by pulling the cable out of the board.
Remove the data cable from the board using a spudger to lift the connector out of the socket.
Loosen the Phillips #0 screw holding the backplane in the system.
To remove the backplane from the chassis, slide the board down, tilt it to a 45 degree angle, and pull the board out.