Apalus Digital Hair Straightening Brush LCD Screen Replacement

はじめに

If you are experiencing issues with the LCD screen on top of the brush, this guide will walk you through on how to take apart the brush in order to replace the screen. Soldering is involved, so if you don't know how to solder take a look at How To Solder and Desolder Connections.

必要な工具と部品

手順1 LCD Screen

Apalus Digital Hair Straightening Brush LCD Screen Replacement, LCD Screen: 手順 1、 1の画像 1

Remove the seven 5mm Phillips #1 screws on the comb-side of the brush.

編集

手順2

Now that the screws are taken out, remove the backside of the comb.

編集

手順3

Unplug the power cord from the insert inside of the brush.
Be careful not to tug on the wires. Hold the insert when removing the power cord.

編集

手順4

Remove the circuit board and heating element from the handle.
This will make it easier to work on for later steps.

編集

手順5

Locate the LED screen on the top side of the circuit board

編集

手順6

Flip the circuit board to start soldering.

編集

手順7

Using the soldering tool, melt the solder holding the LCD screen on the circuit board.
The screen is soldered in 11 places on the circuit board. Melt each of these points and remove the screen.
Soldering Technique Guide

編集

手順8

Now that the LCD screen is removed, use a soldering tool and solder to install the new screen on the circuit board.
Solder at the same 11 points where you previously melted to remove the screen.

編集