メインコンテンツにスキップ

MacBook Pro 16インチの解体情報と修理ガイドです。2019年11月に発売されました。モデル番号はA2141とEMC3347です。

battery not detected ,fan at 100% spin,lagging

Block Image
Block Image

Hi. ok..i try to put new paste on logic board.but... obviously mine mistake what happen.. i disconeccted all connectors but didn't mine battery and in middle of process MB turn on..and i didn't know how to turn it of untill 30 sec he do it.after i assembly again, mine battery won't work and appl os can't see it in system report.also, fans are at 100% and all is lagging.tryed to reset smc but no help.any help would apreciate..thanks

Block Image
回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

ベストアンサー

This looks like the battery board data cable is not properly connected into the ZIF connections. Review Steps 9 to 14 in this guide MacBook Pro 16インチ 2019 バッテリーの交換 take note on the way the ZIF connectors work and make sure the cable is not damaged here's the replacement MacBook Pro 16" BMU Flex Cable

このアンサーは役に立ちましたか?

スコア 2

9 件のコメント:

ok,will check the cable and order.new one.But can u explain me is there a chance that something else is broken,sine MB suddenly by himself turn on while i was doing that?If i remember after the last one of the right side cables disconnected ,he turned on and,since i didn't know how to turn it off,he did it by himself 30 sec after,and in that stage fan eas spinning fully if I am remembering correctly

さんによる

i mean, can battery in that short period of time be broken somehow? it was 75% of battery capacity,and 240 cycle

さんによる

@icyeye - The battery is not the focus here as the communication between the battery to the logic board is not present (that cable). Your screenshot shows the battery is not talking to the logic board.

While you should have disconnected the battery before taking things apart. So you could still have issues but we need to solve the obvious issue first.

Start by checking the ZIF connectors if the latches are correctly set.

さんによる

ok.i edited post and add the picture. maybe u can see if there is something wierd. i only detached the right side of the cable...

さんによる

@icyeye The cable is not fully into the ZIF connector, read again the guide step mentioned above and take it slow and gentle. The cable needs to be fully inserted so none of the gold traces are visible. Gently lift up the latech, thread in the cable, lock the latch.

さんによる

4件以上のコメントを表示

コメントを追加

回答を追加する

icy eye さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 59