評価: 1
1
Every after market screen with digitizer and home button assembly I buy has a defective home button. What's the deal? Am I doing something wrong in the installation process? I did not purchase the front panel assembly from ifixit. I have purchase 5 of these for gen 3 and gen 2 ALL of them have defective home buttons.
I'm trying to avoid spending $69.95 on the one from ifixit. I am now regretting this decision. Any tips?
評価: 1.1千
6
1
1
Check the "z"-spring on the board that the home button come in contact with, it may need to be stretched up a bit to make that contact.
It's the gold piece next to the LCD connector.
このアンサーは役に立ちましたか？
Be careful ... I had the same problem.
Tried two digitizer replacements. On both the home button 'collapsed' and would not spring back after about a week of use
Took the front plate off to try stretching that little "z" spring upwards. It broke off as soon as I touched it!
Still haven't figured out if I can repair without replacing the whole board... not pleased at all.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 1,218
