メインコンテンツにスキップ

Repair and disassembly guides for electronic keyboards.

214回答 すべてを表示

Yamaha psr e343 battery port change

I opened my keyboard after a long time like years and I had the batteries inside it too, so now all the batteries are rushed and the whole battery port is ruined. I did try starting up the keyboard with charger and it lights up but only when I keep pressing the ON button, so I think everything is good it just needs a repair on the battery port.

I needed to know from where to buy this battery port too.

Thanks!!!!!

Block Image

Block Image

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

2件の回答

最も参考になった回答

I think you may struggle to buy just the battery port but if you manage to pry it out you could clean it with rust remover and a wire brush and restore it to a good condition. These parts are normally just some nickel coated plates and springs.

I would try to carefully pry them out of their socket (might need to take them out from the underside though) and then soak them in rust remover, then give them a good scrub with a wire brush. Sometimes you can use finer grit sandpaper to remove the corrosion.

このアンサーは役に立ちましたか?

スコア 2
コメントを追加

@mohitjoshi31517 you can replace the spring terminals from battery assembly, but like @honakrisi already alluded to, it's a PITA however, it is possible. Page 17

Block Image

from the SM PSR E343 Removing it might help you to clean it and possibly restore it. BTW I am a strong believer in Citric Acid as a rust remover. It's considered non-toxic and safer for the environment than most commercially available products

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

回答を追加する

Mohit Joshi さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 30