修理を始めるには コミュニティ ストア

モデル番号A1707。 2017年6月に発売されたこのMacBook Proは、最大3.8 GHzのTurbo Boost搭載の最大2.8 GHzクアッドコアIntel Core i7プロセッサーまでのKaby Lakeプロセッサーを搭載しています。

327回答 すべてを表示

オプション

Trackpad is clicking but the trackpad moves by itself!

Recently I bought a MacBook Pro 2017 A1707 trackpad is clicking but it doesn't track when you move your finger.

It moves by itself and sometimes opens the Lunchpad which is wired. I replaced the trackpad but it was the same then I changed the top case it didn't change anything.

Update (08/22/23)

Block Image

I checked them already, It has 12.60 V. I'wondering how it moves by itself.

Update (08/22/23)

Block Image

I found the pin 41 it is broken but it is ground. what can I do??

Update (08/22/23)

Block Image

It is ACT GND

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
1件のコメント

@armin1 anytime you have a disconnected pin etc.it is advisable that you repair this. Even GND is needed to function and missing ground can give weird results. I suggest you fix that connection and re-evaluate

さんによる

コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

If you replaced the trackpad and the top case and the trackpad cable and you're still unable to use the trackpad properly then there is probably a larger issue with the main logic board or software. Have you tried reinstalling your OS? If the issue persists on a device with a new top case, trackpad, trackpad cable, and clean OS installation then the problem is almost definitely due to a fault on the main logic board. Good luck!

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

4 件のコメント:

"I wanted to reinstall the OS, but when I press the option key to choose a drive or flash drive, the trackpad is still experiencing the same issue. Do you think it will be okay if I proceed with the installation process??"

さんによる

I installed a fresh macOS, but it has the same problem.

さんによる

which part of the board needs to be checked?

さんによる

I'm not sure where the issue would likely be. I'd recommend removing the logic board carefully and then fully inspecting it for any signs of damage. Also, when you replaced the top case did you replace the battery as well?

さんによる

コメントを追加

オプション

@zpl @armin1 here is the Trackpad connector diagram Check those pins on your board. Interesting to see that the trackpad has its own fuse. See if you have the required 12.6V on that. F4500 is just above the connector L4500 and C4500 are on the opposite side. Pin 1 of the connector is the one on the bottom left of your logic board.

Block Image

This is not as to interfere with the troubleshooting by @zpl but just to augment it.

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

1件のコメント:

Nice! Thanks!

さんによる

コメントを追加

回答を追加する

Armin さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 55